Active Speaker Protector

Active Speaker Protector Circuit Design
This is a simple active speaker protector circuit which has a very important use, expecially to protect the loudspeakers of a audio system. It prevent the speaker from noise sound when we turn on the power amplifier. The circuit drives the speakers after 3 to 10 seconds so that the source of the same stabilizes and stops generating cracks and noises that could damage both the speakers and the output transistors of the amplifier. This circuit powered using a 12V regulated power supply. If you have a high power audio system, you may try to build this circuit and mount the circuit in the amplifier box.

Bottom PCB Layout Design | Active Speaker Protector

Active Speaker Protector PCB Layout Design

Top PCB Design | Active Speaker Protector

Active Speaker Protector Component Layout

Speaker Protector Circuit Connection

Active Speaker Protector Connection

Active Speaker Protector Part List

  • 5-pin 12-volt Relay – 2
  • Transistors 2SC945 – 2
  • Transistor 2SC9013 – 1
  • Diodes 1N4007 – 5
  • Elco 220 uF / 50V – 2
  • Resistor 10 KOhms – 4
  • Resistor 1 KOhms – 1
  • Resistor 39 KOhms – 1
  • Large 3-pin connectors – 2
  • Small 3-pin connector – 1
  • Trimpot of 220 KOhms or 500 KOhms – 1

One thought on “Active Speaker Protector

  1. please send to me a delay relay diagram with two led light red and green red led for protection and green led for switch on the relay

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.