Hum Remover Circuit Electronic

“Hum” Remover

Here is the hum remover circuit diagram. “Hum” usually occured from live audio system, for example: input from microphone. Hum can be removed from an audio signal to get the maximum performance by mixing the actual […]

surround speaker placement

Passive Surround

This is the scheme diagram of passive surround circuit. Passive surround doesn’t need any active components and power supply to make the circuit works. The circuit just need the combination of resistors and electrolytic capacitors. Circuit […]

4W stereo amplifier LM2877

4W Stereo Amplifier using LM2877

This is the diagram of 4W stereo power amplifier built based stereo power IC LM2877 with a few of external components. The circuit required single power supply with voltage range of 6VDC – 24VDC. Heatsink is […]

25W Hi-Fi Audio Amplifier based LM1875

25W Hi-Fi Audio Amplifier based LM1875

Here the circuit diagram of 25 watt Hi-Fi (high fidelity) audio amplifier that build based on single power amplifier IC LM1875 that should be run using heatsink attached on its. Components List: R1 _____________ 1K R2 […]

Mic condenser amplifier circuit diagram

Mic Condenser Amplifier

This is the circuit diagram of mic condenser amplifier. The low-cost and compact mic condenser audio amplifier described right here is deliver good-quality audio of 0.5 watts at 4.5 volts. It could possibly be applied as […]

65W Power Amplifier using HEXFET

This is a high quality 65W power amplifier circuit based HEXFET IRF9540 and IRF540. The circuit is quite simple for amplifier with good sound quality. The component parts is easy to find at electronic store around […]

guitar preamp circuit

Guitar Pre-Amp with JFET 2N5457

Designed by Don Tillman, this guitar pre-amp circuit design is dedicated for people who don”t like op-amps module. This circuit is a discrete JFET pre-amplifier design, use 2N5457 as the main component. It has low noise, […]

Low Impedance Microphone Amplifier

This is the circuit diagram of low impedance microphone amplifier. The circuit designed for use with low impedance (~200 ohm) microphones. It will work with regulated voltages between 6-30VDC. If you don’t build the impedance adapter […]

Jimi Hendrix Fuzz Face

Jimi Hendrix Fuzz Face Pedal JH-2

The following diagram is the Jimi Hendrix Fuzz Face Pedal JH-2 circuit diagram. Schematic by Jim Dunlop Note: Q1 & Q2 are MPSA18