NiCd – NiMH Battery Charger

Here is the simple and low cost NiCd and NiMH battery charger circuit which can be used for various battery type and size. This battery charger use a regulator IC of LM317.

Schematic diagram:

NiCd - NiMH Battery Charger circuit diagram
NiCd – NiMH Battery Charger circuit diagram

The charge will start if a battery is connected between pins JP1-JP4 or JP2-JP4 or JP3-JP4. For example, if a battery is connected to JP1-JP4 pins then the current that flows cause a voltage drop to R1, then D1 causes a voltage drop of 0,7 volts and ?1 conducts. Then through transistor’s emitter flows a current that comes from Adjustment pin of LM317.

NiCd – NiMH Battery Charger Circuit Notes:

  • I is 1/10 of the battery’s charging capacity. For example if battery has a rated capacity of 1700mA then ?=170.
  • Diode D4 prevents current to flow from battery back to the charging circuit. Resistors R1,R2 and R3 adjusts the charging current and it’s value is given from : Rx=(1,25 + 0,1) / I , where x = 1,2,3.
  • The input voltage must be at least 3 times the battery’s voltage. For example an input voltage of 25V can charge a 8,4V (9V) battery.
  • R3 is 1/2 Watt and R1 and R2 it’s 1/4 Watt.
  • Pins distribution:
Pins
Battery type
JP1 – JP4
AAA
JP2 – JP4
AA
JP3 – JP4
PP3 & 6F22

PCB top and bottom layout:

NiCd - NiMH Battery Charger pcb layout

NiCd - NiMH Battery Charger component layout

One thought on “NiCd – NiMH Battery Charger

  1. I have a few doubts on this NiMH battery charger circuit.
    >Is there any battery full auto cutt off protection in this circuit?
    If not can you tell how can i implement this?

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.