5 Band Graphic Equaliser

This is the design diagram of 5 band graphic equaliser circuit build using operational amplifier chips, the NE5532 or LM833. The op-amp ICs is a good choice because of inexpensive and comes with fairly good quality output. Each IC contains dual op-amps circuit, so you will need 4 ICs of NE5532 or LM833 to build… Read More »

NiCd – NiMH Battery Charger

Here is the simple and low cost NiCd and NiMH battery charger circuit which can be used for various battery type and size. This battery charger use a regulator IC of LM317. Schematic diagram: The charge will start if a battery is connected between pins JP1-JP4 or JP2-JP4 or JP3-JP4. For example, if a battery… Read More »

2 x 1.2W Dual Power Amplifier with KA2214

This is another stereo / dual power amplifier circuit with power IC KA series. This amplifier delivers dual power output (stereo) at 1.2W for each channel. General The KA2214 is a monolithic integrated dual audio power amplifier in a 14-pin plastic dual in line package. It is designed portable audio sets.

Color Detector

This is the color detector / sensor circuit diagram. This circuit will sense eight colors that are: green, red and blue (as primary colours); magenta, cyan and yellow (as secondary colours); and black and white. It’s will be very useful for robotics project. The circuit is based on the fundamentals of optics and digital electronics.… Read More »

Safe Constant Current Source

In the above circuit diagram, a CMOS operational amplifier (op-amp) controls the current via a P-Channel HEXFET power transistor (IRF9520) to maintain a constant voltage across R1. The current is given by: 1 = VREF/R1. The benefits of this configuration are:

Six LED Stereo VU Display

The following image is the scheme diagram of six LED stereo VU display circuit which build using Dot/Bar Display Driver IC LM3915. This VU display should be connected before amplifier module circuit. You may connect this circuit at pre-amp output, tone control input/output or equaliser input/output. This circuit powered with 12V DC supply. About LM3915:… Read More »

UniVibe Pedal

The Univibe is actually a footpedal-operated phaser or phase shifter for generating chorus and vibrato simulations for electric organ or guitar. It was introduced in the 1960s by Shin-ei, and was intended to emulate the “Doppler sound” of a Leslie speaker. Although not a really successful Leslie-simulator, the Univibe has turn out to be an… Read More »

Univox Super-Fuzz Pedal

This is the circuit diagram of Univox Super-Fuzz Pedal. This pedal is actually a 69-to-early 70″s design that consists of two special capabilities. They are the octave generation effect from the differential-pair-with-collectors -tied-together along with the option of just a clipping amplifier or a 1kHz notch for different sounds.


Page 4 of 58« First...23456...102030...Last »