500W RMS Power Amplifier Based MOSFET

500W RMS Power Amplifier Circuit based Mosfet

This is 500W RMS power amplifier circuit design, build based on MOSFET. The circuit is very popular in EE audio hobbyist as “LEGEND stage Master MK2”. It is a very good and powerful amplifier. It uses 12x power MOSFET IRFP240.

To achieve even greater power, and they were often interested young friends, was developed even stronger version is capable of producing a full and true 500W RMS into 8 ohms. With such large forces had to resort to a radically different solution some degree, for even better reliability, or has increased the complexity of the tiles so that for this version is impossible to use the same tile as the previous two lower models (Legend and Legend Stage Master).

Specification:

Output power ——— 500W RMS / 8 ohms
Frequency range 15Hz-130kHz (-1dB) at 30W RMS
THD = <0.18% (at 1 kHz and 500 W)
THD = <0.01% (at 1 kHz and 400W and below this power)
BIAS around 25mA per output pair

500W RMS Power Amplifier PCB Design and Layout

This is the PCB design and component placement, you should mount the MOSFET on the heatsink to prevent overheating and maintain the performance of power amplifier.
500W RMS Power Amplifier PCB Design

500W RMS Power Amplifier Top PCB Layout

This circuit designed by Dr Borivoje Jagodic >> original page for the reference.


Incoming Search: layout power ampli, legend master mk2, legend mk2 lay out pcb schematics, leoend amp pcb and laout, mosfet based power amplifier

2 thoughts on “500W RMS Power Amplifier Based MOSFET

  1. ROY SINGH

    CAN YOU SUPPLY ME WITH THE COMPLETED PCB AND COMPONENTS LAYOUT SO THAT I CAN BUILD THIS ONE, IF SO WHAT IS THE PRICE OF THE PCB AND SUPPLY ME WITH THE COMPONENTS ASWELL

  2. Pingback: 250W RMS Power Amplifier Legend Stage Master - Schematic Design

Leave a Reply

Your email address will not be published. Required fields are marked *