Ultra Bright LED Emergency Light

LED Emergency Light Circuit Diagram

This is LED emergency light that will turned on automatically when mains supply fails, and turned off when mains power resumes. This circuit produces highly bright because the use of ultra bright white LEDs. This circuit also has its own battery charger. When the battery is fully charged, the charging process will stop automatically.

Components List:

R1           = 180R - 1/2W
R2           = 1.2K
R3 - R14     = 100R - 1/2W
R15          = 1K - 1/2W
R16          = 16R/5W
VR1          = 2.2K
C1           = 1000uF/25V
D1-D5        = 1N4007
D6           = 6.8V - 0.5W Zener
LED1 - LED12 = Ultrabright White LEDs
T1           = BC548
T2           = BD140
B1           = 6V - 4.5Ah Rechargable Battery
IC1          = LM317
T1           = 9VAC-Transformer

The circuit contains two important blocks: charger power supply section and LED driver section.

Charger Section

The charger power supply section is built around 3-terminal adjustable regulator IC LM317 (IC1), while the LED driver section is built around transistor BD140 (T2).

In the charger power supply section, input AC mains is stepped down by transformer X1 to deliver 9V, 500 mA to the bridge rectifier, which comprises diodes D1 through D4. Filter capacitor C1 eliminates ripples. Unregulated DC voltage is fed to input pin 3 of IC1 and provides charging current through diode D5 and limiting resistor R16. By adjusting preset VR1, the output voltage can be adjusted to deliver the required charging current.

When the battery gets charged to 6.8V, zener diode ZD1 conducts and charging current from regulator IC1 finds a path through transistor T1 to ground and it stops charging of the battery.

LED Driver

In this LED emergency light circuit, the LED driver section uses a total of twelve 10mm white LEDs. All the LEDs are connected in parallel with a 100-ohm resistor in series with each. The common-anode junction of all the twelve LEDs is connected to the collector of pnp transistor T2 and the emitter of transistor T2 is directly connected to the positive terminal of 6V battery. The unregulated DC voltage, produced at the cathode junction of diodes D1 and D3, is fed to the base of transistor T2 through a 1K ohm resistor.

When mains power is available, the base of transistor T2 remains high and T2 does not conduct. Thus LEDs are off. On the other hand, when mains fails, the base of transistor T2 becomes low and it conducts. This makes all the LEDs (LED1 through LED12) glow.

The mains power supply, when available, charges the battery and keeps the LEDs off as transistor T2 remains cut-off. During mains failure, the charging section stops working and the battery supply makes the LEDs glow.

You can construct this LED emergency light circuit on a general-purpose PCB and mount the circuit in a plastic with enough space for battery and switches. Mount the LEDs on the cabinet such that they light up the room. A hole in the cabinet should be drilled to connect 230V AC input for the primary of the transformer.

Note: Since the transistor T2 can deliver up to 1.5A with proper heatsink, you may use more LEDs provided the total current consumption does not exceed 1.5A. Standar LED current consumption is about 20mA only. 🙂

Incoming Search: rechargeable emergency light circuit diagram, led 715 circuit diagram

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.