For better results, assemble the circuit on a good-quality glass epoxy board and house the transmitter inside an aluminium case. Shield the oscillator stage using an aluminium sheet.
Coil winding details are given below:
L1 ? 4 turns of 20 SWG wire close wound over 8mm diameter plastic former.
L2 ? 2 turns of 24 SWG wire near top end of L1. (Note: No core (i.e. air core) is used for the above coils)
L3 ? 7 turns of 24 SWG wire close wound with 3mm diameter air core.
L4 ? 7 turns of 24 SWG wire-wound on a ferrite bead (as choke)