The following is a circuit of a power amplifier 140W. This Circuit using 741 IC-based circuit opAmp as strengthening early before the final strengthening by four transistors thereafter. Make sure you use a heatsink on the transistors to reduce excess heat in the transistors.
Power supply used is the type of dual polarity power supply with (+), (-) and (0). For maximum performance, use a stabilized power supply with 40V output voltage and output current of 5A. Do not forget to use the good speakers to get good audio output as well .. 🙂
Good luck …
Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…
This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…
Here is the remote control tester circuit. This circuit is really a simple and easy…
This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…
The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…
This is the circuit diagram of white line follower toy. The actuator of the toy…
View Comments
wrong emitter collector tap in the output pnp transistor..the emitter should be tap in the resistor .47 going to vcc section
this is good circuit diagram but something wrong look this NPN , PNP the No. of 2n3055 & mj2955 and the all. transistor.
Thank you
140 watts amp diagram layout