Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are very cheap and easy to find in the electronic market in your area. The circuit has been assembled and tested with very good performance.
This 200W MOSFET amplifier circuit designed for single or mono audio channel application. You should build two similar circuits for stereo audio application. Build one first for performance testing to ensure that this circuit really wongking well with great audio performance.
The power supply used for this circuit is a symmetrical / dual polarity type. You need 4 amperes minimum of transformer with +/- 45V output. For stereo application, use about 8 amperes, although the 5A transformer is good enough 😀 . You may use the power supply circuit design on this post: 200W Power Amplifier using Transistor
Bottom / Chopper PCB Design
Top PCB Design / Component Placement
Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…
This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…
Here is the remote control tester circuit. This circuit is really a simple and easy…
This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…
The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…
This is the circuit diagram of white line follower toy. The actuator of the toy…
View Comments
ok, loving this, due to 2 reasons
1. it uses same mosfet in both top and bottom sides
2. it has hum breaking resistor (10ohm near left input ground) this resistor breaks hum when used with 6 channels for 5.1. thank you. plz explain this circuit functioning more. thanks
Bonjour. Très excellent d'amplificateur audio. Est ce que possible de multiplier le nombre finale (IRFP250), Exemple: au lieu de 4finaux, On fait 8finaux. Et ensuite on augmente alimentation (Exemple 2*75V DC). Car j'ai besoin plus de puissance.
Cordialement !
how do we adjust the trimmer(5k)?thanks.