This is 25W low power inverter which contain of only 9 parts and turn 10VDC – 16VDC into 115V / 60Hz square wave power. This circuit has capability to operate AC equipment up to 25W.
The first section of the 555 timer is wires as an astable oscillator with R2 and C1 setting the frequency. The output is available at pin 5. The second section is wired as a phase inverter. That output is available at pin 9. Resistor R3 and R4 keep output transistor Q1 and Q2 from loading down the oscillator.
The two transistors drive the transformer push-pull fashion. When one transistor is biased-on, the other is cut-off. The transformer is a 120V/18V center tapped that is connected backwards, so that is steps the voltage up rather than down. Oscillator circuit U1, R1, R2 and C1 operates from about 4 to 6V with very stable output.
Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…
This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…
Here is the remote control tester circuit. This circuit is really a simple and easy…
This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…
The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…
This is the circuit diagram of white line follower toy. The actuator of the toy…
View Comments
hi guyz!
i want to request from you if you could publish or share to me a circuit diagram
for 18vdc to 110vac 50w inverter. I really need this for my project. plz can u paste this before 12h-00 tomorrow 08/06/2011 and data manual
thanks
regard tjabadi m
hi there!
this power supply is very simple yet superb. thanks for this.
i want to request from you if you could publish or share to me a circuit diagram
for 12vdc to 24vdc. I really need this for my project. i have here a car battery and a solar charger, and my project is 24vdc.
thanks
ronell
This circuit is very easy and yet very useful. Thanks for providing such significant information.