Linear Amplifier

300W RMS Stereo Power Amplifier based IC TDA7294


This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four pieces of power IC TDA7294. It’s mean that every single channel of the circuit uses two ICs in bridge mode. In this application, the load value must not be less than 8 Ohms.

The main advantages of this solution are the following:
– High power with low voltage.
– Considerable power, even at high load values (Up to 16 Ohm).
With a load of 8 Ohms and a power supply voltage of ± 25V, the maximum performance that can be obtained is 150 W per channel. While with 16 Ohms load, and a power supply voltage of ± 35V, we will have a maximum of 170 W per channel.

This 300W RMS stereo power amplifier require symmetrical power supply to work, the circuit diagram is included in this post.

300W RMS Stereo Power Amplifier Schematic Design

300W RMS Stereo Power Amplifier Part List

SEMI-CONDUCTORS
4 TDA 7294

RESISTORS
56K Ohms (green, blue, orange) : 8
8K2 Ohms (gray, red, red) : 3
5K1  Ohms (green, brown, red) : 14
8.2 Ohms 1W (gray, red, gold) : 4
2.7 Ohms 1W (red, purple, gold) : 4
22K Ohms (red, red, orange) : 2
1K Ohms (brown, black, red) : 4

CAPACITORS
4700 uF / 35v electrolytic capacitor : 2
22 uF / 35v electrolytic capacitor : 12
1 uF / 35v electrolytic capacitor : 4
0.1 uF / 250v polyester capacitor : 4
0.1 uF / 100v polyester capacitor : 4
0.47 uF / 100v polyester capacitor : 4
10 pF / ceramic capacitor : 4
390 pF / ceramic capacitor: 2

MISCELLANEOUS
25-amp diode bridge : 1
Diodes 1N4148 : 2
fuse holders for printed and 6 amp fuse : 4
small 3-pin connectors : 2
large 3-pin connectors : 2
small 6-pin connector : 1
18x18v to 12 Amp transformer : 1
Square mica insulation. : 4
coils of 10 coils with air core : 4
Of 1/4 inch and wire 18.

The resistance of the 12v cooler is calculated:
(15 / milliamperes of fan) = x Ohms.

300W RMS Stereo Power Amplifier PCB Layout Design

Power Supply for 300W RMS Stereo Power Amplifier

circuit schematic

View Comments

Recent Posts

Switched ON Bike Lamp

Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…

55 years ago

3A Switching Power Supply Regulator

This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…

55 years ago

Remote Control Tester

Here is the remote control tester circuit. This circuit is really a simple and easy…

55 years ago

Current Output Multiplier for 78xx Regulator

This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…

55 years ago

4 Transistor FM Tracking Transmitter

The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…

55 years ago

White Line Follower

This is the circuit diagram of white line follower toy. The actuator of the toy…

55 years ago