This cut phone line detector circuit is used to detect whether your phone line is active or not.
Components List:
R1,R2,R3 = 22M Ohms
R4 = 2.2M Ohms
C1 = 0.47uF/250V Mylar caps
D1 = 1N914, NTE519, or other small signal diode
Q1 = 2N3904, NTE123AP
Q2 = 2N3906, NTE159
Q3 = IRF510, NTE2382,? MosFet
This kind of circuit speaks for itself. While the phone line is okay, Q1 works as a short that has a extremely high resistance/ohms value via R1, R2, and R3 for a total close to 66 MegaOhm, so it is very high. When the phone line is cut (open), it triggers the MosFet (Q3) via transistor Q2 to drive the load. Replacements are acceptable, not one of the parts are crucial.
The ‘LOAD’ can be anything you like. A lamp, relay, motor, tape-recorder, stereo, security system, or anything else.
Remember that telephone providers do not like to have anything ‘directly’ connected to their wire connections for apparent reasons, so work with this circuit at your own risk. If you want to experiment with it safely, work with an Opto-Isolator or something…
Circuit designed by Tony van Roon
Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…
This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…
Here is the remote control tester circuit. This circuit is really a simple and easy…
This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…
The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…
This is the circuit diagram of white line follower toy. The actuator of the toy…
View Comments
hi,
in case of outgoing call , how can i find out the call is attended or not.
Thanks ,
do you have a circuit that gives the location of the cut phone line??