This is the circuit diagram of portable mic preamp. This circuit consumes low current supply (about 2mA), so will have a long battery life for supplying the circuit. Harmonic distortion is about 0.1% @ 1V RMS output for all frequencies. Maximum input voltage (level control cursor set at maximum) = 25mV RMS. Maximum input voltage (level control cursor set at center position) = 200mV RMS
This small portable mic preamp circuit is based on a low noise, high gain two stage PNP and NPN transistor amplifier, using DC negative feedback through R6 to stabilize the working conditions quite precisely. Output level is attenuated by P1 but, at the same time, the stage gain is lowered due to the increased value of R5. This unusual connection of P1, helps in obtaining a high headroom input, allowing to cope with a wide range of input sources (0.2 to 200mV RMS for 1V RMS output).
Resistors:
R1,R2,R3 = 100K
R4 = 8K2
R5 = 68R
R6 = 6K8
R7,R8 = 1K
R9 = 150R
P1 = 2K2 Linear Potentiometer
Capacitors:
C1 = 1uF/6.3V polyester
C2,C3,C4 = 100uF/25V elco
C5 = 22uF/25V elco
Transistors:
Q1 = BC560C
Q2 = BC550C
Misc:
J1 = Jack socket (Mono 3 or 6 mm.)
Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…
This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…
Here is the remote control tester circuit. This circuit is really a simple and easy…
This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…
The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…
This is the circuit diagram of white line follower toy. The actuator of the toy…
View Comments
Pls i need 5kva power inverter diagram 4 my school practical thanks. From darex federal polytechnic ado ekiti and dis my email badejo_emmanuel@yahoo.com.