Categories: Tone Control

12V Stereo Tone Control

The following diagram is the circuit diagram of low cost 12V stereo tone control which also available in kit, you may find the kit at electronic part store around your place.

The circuit build based on ordinary tone control circuit, using two low cost transistors FCS9014 in each channel, so there are will be four transistors in this 12v stereo tone control. Take a note that you must connect the circuit before the amplifier module. The output of tone control must be connected to the input of the amplifier. Any small signal NPN transistor such as BC547B, 2N3904, C828, or C945 can be used to replace FCS9014.

There are will be four potensiometers used for this tone control circuit: volume level, bass level, treble level and balance adjustment. For better result, use better components with small tolerance value for example metalfilm resistors, MKM capacitor etc.

This circuit powered with 12V DC power supply, you may use regulated power supply for better performance. Just use regulator IC of LM7812 to get regulated voltage. 🙂

circuit schematic

Share
Published by
circuit schematic

Recent Posts

Switched ON Bike Lamp

Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…

55 years ago

3A Switching Power Supply Regulator

This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…

55 years ago

Remote Control Tester

Here is the remote control tester circuit. This circuit is really a simple and easy…

55 years ago

Current Output Multiplier for 78xx Regulator

This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…

55 years ago

4 Transistor FM Tracking Transmitter

The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…

55 years ago

White Line Follower

This is the circuit diagram of white line follower toy. The actuator of the toy…

55 years ago