Categories: Audio

Dynamic Mic Compressor

The circuit below is a Dynamic Mic Compressor circuit which is simple, easy to built, inexpensive but the results are quite satisfactory. Audio output sounded outstanding.

The principle of this circuit is very simple, the first transistor is used as microphone pre-amplifier. Then a second transistor used as a buffer. And the third transistor is a feedback circuit. A very sensitive electret microphone used in this circuit.

Supply voltage of this Dynamic Mic Compressor circuit must be 12 Volt. Highly recommended to use its own power supply, do not use a shared power supply from another electronic circuit module. Regulated circuit with fine/good cable and good grounding is recommended to minimize hum.

circuit schematic

Share
Published by
circuit schematic

Recent Posts

Switched ON Bike Lamp

Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…

55 years ago

3A Switching Power Supply Regulator

This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…

55 years ago

Remote Control Tester

Here is the remote control tester circuit. This circuit is really a simple and easy…

55 years ago

Current Output Multiplier for 78xx Regulator

This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…

55 years ago

4 Transistor FM Tracking Transmitter

The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…

55 years ago

White Line Follower

This is the circuit diagram of white line follower toy. The actuator of the toy…

55 years ago