Categories: Equalizer

2 x 10 Band Stereo Graphic Equaliser

The following diagram is the circuit diagram of 20 band stereo graphic equaliser which will controlling the audio signal in specific frequency range.

The power supply used for this circuit is symmetrical (dual polarity) type, 15V DC.

This circuit must be connected before the amplifier circuit. For maximum performance, you may use high quality electronic component such as metalfilm resistor, MKM capacitor (nonpolar), tantalum capacitor (bipolar). You may replace the power supply module with regulated and stabilized power supply or just add IC LM7815 after R35 and IC LM7915 after R36. With good components and good power supply, then the sound quality will get better. This circuit uses 6x IC TRX6221, if you can’t find this IC at your area then you may try NE5532 or LM833 operational amplifier IC.

circuit schematic

Recent Posts

Switched ON Bike Lamp

Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…

55 years ago

3A Switching Power Supply Regulator

This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…

55 years ago

Remote Control Tester

Here is the remote control tester circuit. This circuit is really a simple and easy…

55 years ago

Current Output Multiplier for 78xx Regulator

This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…

55 years ago

4 Transistor FM Tracking Transmitter

The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…

55 years ago

White Line Follower

This is the circuit diagram of white line follower toy. The actuator of the toy…

55 years ago