Categories: Audio

Stereo VU Booster

This is a stereo VU booster circuit diagram based on transistor FCS9014 which usually used for pre-amp and regulator circuit and switching. With simple circuit design, this device could be built easily. Scheme diagram, bottom PCB layout and component placement provided on the following image:

This circuit should be connected to audio channel before amplifier module. If you are using tone control or equaliser module, it’s better to connect this circuit to the wire connection before tone control / equaliser.

The transistors boost the audio signal from the input and then forward the signal to the VU meters. Adjust the VR/potensiometer to get the best sensivity of VU meter.

This stereo VU booster circuit works with wide range of supply voltage, 12VDC to 40VDC, you may connect this circuit parallel with amplifier circuit.

circuit schematic

Share
Published by
circuit schematic

Recent Posts

Switched ON Bike Lamp

Do you have a bicycle..? why don't try to build this circuit..?. Powered using battery…

55 years ago

3A Switching Power Supply Regulator

This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the…

55 years ago

Remote Control Tester

Here is the remote control tester circuit. This circuit is really a simple and easy…

55 years ago

Current Output Multiplier for 78xx Regulator

This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By…

55 years ago

4 Transistor FM Tracking Transmitter

The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes…

55 years ago

White Line Follower

This is the circuit diagram of white line follower toy. The actuator of the toy…

55 years ago